Highfields Amateur Radio Club
Constructors Corner.
smoking soldering iron
copyright date

Cloning instructions For:
DJ-S40, DJ-S446.
DJ-S40, DJ-S446.
By Brian, MW0GKX.

These radios use a lead that is the same as the Icom OPC-474
connection diagram

  1. With both radios off, connect the cloning cable to the speaker jack of the MASTER and SLAVE transceivers (right).

  2. Turn both radios on.

  3. On the MASTER radio, while holding the [MONI] key press and release the [PTT] 3 times.
    "CLonE" appears and the transceiver enters the clone mode.

  4. Press the [PTT] on the MASTER and the data is sent to the SLAVE.
    "Sd ***" is displayed on the MASTER.
    "Ld ***" is displayed on the SLAVE.
    When cloning is finished "PASS" is displayed on the MASTER and "Ld 078" is displayed on the SLAVE, check the MASTER as the SLAVE cannot tell if the data was passed correctly.
    If "CHECK" shows on the display the cable has become disconnected. Re-fit cable and try again.

  5. Once cloning has completed sucessfully, turn power for both radios off and remove the connecting cable. When powered on again the radios will return to normal operation.

Constructors Corner Index Page.
Information Home.
Or Sitemap.